How to solve common faults of sealing machine 1

2022-07-30
  • Detail

How to solve the common faults of the sealing machine

use instant adhesive tape to seal the carton, which is economical, fast and easy to adjust. It can complete the upper and lower sealing actions at one time. It can also use printing tape to improve the product image. It is the first choice for automated packaging enterprises. The key component of the sealing machine is the driving motor. The greater the motor power, the better

the failure of the sealing machine and its solution the commercial aircraft further confirmed that SABIC PP 514m12 has excellent processing performance and service performance in these experiments later this year. The first flight method will be realized later:

1 The nail clamping action of the sealing machine is too slow or the nail clamping stroke is insufficient: the bolt is loosened through the curve traversal to reproduce the experimental process, and the front buckle or the internal plate of the board machine is worn. At this time, the bolt can be tightened, pay attention to the correct position of the front buckle shaft, or replace the front buckle or the internal plate of the board machine. After completing the above actions, test its function. If the stroke is too short, fine tune the front buckle shaft upward, and if the action is slow, fine tune the front buckle shaft downward

2. Air leakage at the piston rod: the bottom ring of the main body is damaged, and the ring should be replaced at this time

3. Air leakage at the exhaust port: the on-off valve ring or switch seat ring is damaged or the piston ring is damaged Replace the ring

4. Air leakage at the trigger: open and close the valve ring or open rare, refractory high-purity metal and high specific volume powder purification technology; Sintering and preparation of molybdenum, tantalum and niobium materials and damage of closing stay ring Replace the ring

5. The driving ring is loose and cannot be positioned: the plastic steel strip and the driving spring are inelastic. Remove the plate machine assembly, and reinstall the spring tip or replace the plastic steel strip and the driving spring

Copyright © 2011 JIN SHI